Enhancing the stability of retaining walls through Kevlar reinforcement

Authors

DOI:

https://doi.org/10.66104/bmzjan61

Keywords:

Retaining walls, Kevlar reinforcement, Concrete, Elastic modulus, Displacement behavior

Abstract

Retaining walls are widely used to support soil masses and protect roads, railways, buildings, and other infrastructure against lateral earth pressure. Controlling their deformation is essential for maintaining serviceability and reducing the risk of cracking and progressive deterioration. This study presents a preliminary analytical investigation into the effect of incorporating 5% Kevlar fibers into concrete used for retaining wall panels. The effective elastic modulus of ordinary and Kevlar-reinforced concrete was estimated using a mixture-law approach, while an analytical formulation was applied to evaluate the displacement-to-height ratio of wall panels with heights ranging from 1 to 7 m. The results show that the addition of Kevlar increases the elastic modulus from 30 to 32.6 GPa, corresponding to an improvement of approximately 8.67%. A consistent reduction in the displacement ratio was also observed for all the wall heights considered. For example, at a height of 7 m, the ratio decreased from 0.00063 for ordinary concrete to 0.00058 for Kevlar-reinforced concrete. These findings indicate that Kevlar fibers may improve the stiffness and deformation resistance of concrete retaining wall panels. However, the present results are analytical and preliminary. Experimental validation, numerical modeling, durability assessment, and soil-structure interaction analysis are required before practical application.
Views: 374Downloads: 285

Downloads

Download data is not yet available.

Author Biographies

  • Abdelmoutalib Benfrid, Djillali Liabès University in Sidi Bel Abbès, Algeria.; The University Centre of Maghnia, Algeria.; Libyan Society for Research and Scientific Studies

    Djillali Liabès University in Sidi Bel Abbès, Algeria.; The University Centre of Maghnia, Algeria.; Libyan Society for Research and Scientific Studies

  • Krzysztof Murawski, Jacob of Paradies University of Gorzów Wielkopolski, Poland.

    Jacob of Paradies University of Gorzów Wielkopolski, Poland.

  • Milad Khatib, Engineering Department, ISSAE-Cnam Lebanon, Beirut, Lebanon

    Engineering Department, ISSAE-Cnam Lebanon, Beirut, Lebanon

  • Ahmed Boukhari, Department of Civil Engineering, Faculty of Architecture and Civil Engineering, University of Science and Technology of Oran Mohamed Boudiaf - USTO-MB (Oran 31000), Algeria

    Department of Civil Engineering, Faculty of Architecture and Civil Engineering, University of Science and Technology of Oran Mohamed Boudiaf - USTO-MB (Oran 31000), Algeria

References

1. Harrat, Z.R., Amziane, S., Krour, B., Bouiadjra, M.B., 2021. On the static behavior of nano SiO₂ based concrete beams resting on an elastic foundation. Computers and Concrete, 27(6) :575.

2. Mohammed, C., Baghdad, K., Zouaoui, R.H., Sofiane, A., Bouiadjra, M.B., 2022. Bending analysis of nano-SiO₂ reinforced concrete slabs resting on elastic foundation. Structural Engineering and Mechanics, 84(5) :685–697.

3. Benfrid, A., Benbakhti, A., Harrat, Z.R., Chatbi, M., Krour, B., Bouiadjra, M.B., 2023. Thermomechanical analysis of glass powder based eco-concrete panels : Limitations and performance evaluation. Periodica Polytechnica Civil Engineering, 67(4) :1284–1297.

4. Dine Elhennani, S., Harrat, Z.R., Chatbi, M., Belbachir, A., Krour, B., Işık, E., Bouiadjra, M.B., 2023. Buckling and free vibration analyses of various nanoparticle reinforced concrete beams resting on multi-parameter elastic foundations. Materials, 16(17) :5865.

5. Kecir, A., Chatbi, M., Harrat, Z.R., Bouiadjra, M.B., Bouremana, M., Krour, B., 2024. Enhancing the mechanical performance of concrete slabs through the incorporation of nano-sized iron oxide particles (Fe₂O₃) : Non-local bending analysis. Periodica Polytechnica Civil Engineering, 68(3) :842–858.

6. Chatbi, M., Harrat, Z.R., Benatta, M.A., Krour, B., Hadzima-Nyarko, M., Işık, E., Bouiadjra, M.B., 2023. Nano-clay platelet integration for enhanced bending performance of concrete beams resting on elastic foundation: An analytical investigation. Materials, 16(14) :5040.

7. Harrat, Z.R., Chatbi, M., Krour, B., Hadzima-Nyarko, M., Radu, D., Amziane, S., Bouiadjra, M.B., 2023. Modeling the thermoelastic bending of ferric oxide (Fe₂O₃) nanoparticles-enhanced RC slabs. Materials, 16(8) :3043.

8. Chatbi, M., Harrat, Z.R., Ghazoul, T., Bouiadjra, M.B., 2022. Free vibrational analysis of composite beams reinforced with randomly aligned and oriented carbon nanotubes, resting on an elastic foundation. Journal of Building Materials and Structures, 9(1) :22–32.

9. Benbakhti, A., Benfrid, A., Harrat, Z.R., Chatbi, M., Bouiadjra, M.B., Krour, B., 2024. An analytical analysis of the hydrostatic bending to design a wastewater treatment plant by a new advanced composite material. Journal of Composite and Advanced Materials, 34(2).

10. Benfrid, A., Bouiadjra, M.B., 2024. Investigation of instability in waste glass-based eco-concrete panels under thermomechanical buckling loads. Studies in Engineering and Exact Sciences, 5(2) : e6886.

11. Khetir, H., Benfrid, A., Bouiadjra, M.B., Harrat, R.Z., Chatbi, M., 2024. Mechanical instabilities of nano-composite plates using elasticity theories. Studies in Engineering and Exact Sciences, 5(2) : e5409.

12. Benfrid, A., Chatbi, M., Harrat, Z.R., Bouiadjra, M.B., 2025. Selective integration of waste-derived glass nanopowders in structural wall concrete: Improving thermal efficiency and elasto-mechanical properties for sustainable construction. Periodica Polytechnica Civil Engineering.

13. Abderrahmane, M.A., Ahmed, F., Abdelghani, I., Mohammed, C., Ahmed, B., Youcef, B., Abdelkader, B., 2025. Innovative theoretical approaches for analyzing functionally graded plates : Integrating shear and thickness effects. Composite Interfaces :1–22.

14. Al-Ani, A.A., Hilal, N., Muthusamy, K., Chatbi, M., Harrat, Z.R., 2025. Static and dynamic analysis of bridge decks reinforced with nanoparticles.

15. Bouafia, A., 2018. Stabilité des murs rigides de soutènement. In: Calcul des ouvrages géotechniques - Problèmes résolus.

16. Djadouni, H., Trouzine, H., Belabdelouahab, F., Lazizi, A., 2015. Utilisation des pneus usés derrière un mur de soutènement : Impact environnemental. In : Proceedings of the 13th Arab Structural Engineering Conference (ASEC 2015), Blida, Algeria.

17. Bouafia, A., 2019. Dimensionnement réglementaire des murs de soutènement. In : Introduction à la réglementation géotechnique, Tome II : Murs et écrans de soutènement, calcul parasismique. OPU, Alger.

18. Acharya, P., Zheng, L., Macciotta, R., Liu, F., 2023. Field monitoring and change detection of municipal infrastructure using cost-effective techniques. In : Proceedings of GeoSaskatoon 2023, Saskatoon, Canada.

19. Abe, K., 2022. Numerical study on aseismic reinforcement method for leaning-type retaining wall. In: Proceedings of the 20th International Conference on Soil Mechanics and Geotechnical Engineering, Sydney, Australia.

20. Guerrin, A., Lavaur, R.C., 1976. Traité du béton armé - Murs de soutènement et murs de quai, Vol. 7.

21. Al-Daraji, M., Aljalawi, N., 2024. The effect of Kevlar fibers on the mechanical properties of lightweight perlite concrete. Engineering, Technology and Applied Science Research, 14(1) :12906–12910.

22. Li, Y.F., Yang, K.H., Hsu, P.Y., Syu, J.Y., Wang, S.J., Kuo, W.S., Tsai, Y.K., 2023. Comparing mechanical characterization of carbon, Kevlar, and hybrid-fiber-reinforced concrete under quasistatic and dynamic loadings. Buildings, 13(8) :2044.

23. Wang, Y., Hu, X., 2016. Benefits of short Kevlar fiber reinforcement at the interface for repair of concrete-like materials. Journal of Materials in Civil Engineering, 28(9) :04016087.

24. Mola, E., Bayrak, O.Ü., Baş, F.İ., Bayata, H.F., 2024. Investigating the usability of Kevlar and steel fibers as a hybrid in concrete pavements. Sigma Journal of Engineering and Natural Sciences, 42(2) :344–355.

25. Li, Y.F., Huang, Y.R., Syu, J.Y., Tsai, Y.K., Huang, C.H., 2023. A study on mechanical behavior of Kevlar fiber reinforced concrete under static and high-strain rate loading. International Journal of Protective Structures, 14(3) :407–437.

26. Ike, C.C., 2023. A third-order shear deformation plate bending formulation for thick plates : First principles derivation and applications. Mathematical Models in Engineering, 9(4) :144–168.

27. Ike, C.C., 2022. Generalized integral transform method for the bending analysis of clamped rectangular thin plates. Journal of Computational Applied Mechanics, 53(4) :599–625.

28. Turan, F., Başoğlu, M.F., Zerin, Z., 2017. Analytical solution for bending and buckling response of laminated non-homogeneous plates using a simplified-higher order theory. Challenge Journal of Structural Mechanics, 3(1) :1–16.

29. Turan, F., 2024. Critical buckling load analysis of porous orthotropic two-layered cylindrical panels based on trigonometric shear deformation theory. Iranian Journal of Science and Technology, Transactions of Civil Engineering :1–17.

30. Murawski, K., Shvets, A., Kiss, L.P., 2025. FEM buckling, stress and strain analysis of very slender rectangular (box-section) columns fixed at one end. Stability of Structures - Journal of Critical Engineering.

31. Benfrid, A., Murawski, K., Khatib, M. et Boukhari, A. (2026). Homogénéisation numérique du béton armé de poudre d'aluminium basée sur la méthode de Mori Tanaka. Journal International Review of Research Studies , 1 (09), 1-11.

32. Kahlouche, R., Benfrid, A., Ferkous, S. A., & Yahi, T. E. (2026). Analytical predictive modeling of the mechanical and thermal characteristics of concrete walls altered by pumice powder. Research on Engineering Structures and Materials. Advance online publication.

33. Benfrid, A. (2026, May 21–22). Local instability of polymer plates reinforced with nanocomposite materials [Conference paper]. 6th International Gaziantep Scientific Research Congress, Gaziantep, Türkiye.

34. Mohammedi, M. N., Benfrid, A., Benatta, M. A., Bouiadjra, M. B., & Krour, B. (2026). Effective mechanical properties of eco-concretes reinforced with bio-sourced calcium carbonate nanoparticles: Free vibration analysis of simply supported slabs. Zaštita Materijala. Advance online publication.

35. BENFRID, A. (2026). Prediction of Thermal and Mechanical Properties of Eco-Concretes Using a Biphasic Homogenization Approach. In Prediction of Thermal and Mechanical Properties of Eco-Concretes Using a Biphasic Homogenization Approach. Zenodo.

36. Mohammedi, M. N., Altarhouni, L. A. M., Alsbhawy, M. A. A., Benfrid, A., Benatta, M. A., Bachir Bouiadjra, M., & Krour, B. (2026). Elasto-nano-mechanical characterization of bio-derived nano-CaCO₃-reinforced sustainable eco-friendly concretes for CO₂ emission reduction: Free vibration analysis of raft foundations. Veredas do Direito, 23(7), e236320.

37. Benfrid, A. (2026). The elastomechanical properties of concrete expanded with aluminum nano-inclusions. Journal International Review of Research Studies, 1(02), 1-9.

Published

2026-07-09

How to Cite

Benfrid, A., Murawski, K., Khatib, M., & Boukhari, A. (2026). Enhancing the stability of retaining walls through Kevlar reinforcement. Journal International Review of Research Studies, 1(10 - October), 1-13. https://doi.org/10.66104/bmzjan61

Similar Articles

1-10 of 41

You may also start an advanced similarity search for this article.

Most read articles by the same author(s)